Note:  The button lights will blink as the projector turns on.

     2. Press the Wired PC/Mac button on the push button   box.

• Plug the 15-pin VGA cable into your laptop.
• Plug in the audio cable into your laptop audio source jack

• For computer use w/audio

Press the power button on the amplifier

Press the V-Source & VDP on the amplifier

       (note: make sure the monitor button is NOT on!)

Turn on your laptop at this time--Your image should appear on both laptop screen & projected screen.

.         If image does not appear & using a Macintosh, hold the OPTION button & press F7 to toggle the screens.

If using a Gateway, hold the FN key while pressing the F3 key.        

• For video tape use w/audio press the VIDEO button on the push button box.

Press the POWER button on the VCR

(located on the top shelf of teaching station)

Press V-Source & VCR buttons on the amplifier

       (note: make sure the monitor button is NOT on!)

• When you are finished, press the Off button on the push button box.

      9.  Power switch for the electric screen is located to the left of the audio cabinet.